 |
JEEP WIRING HARNESSES |
| FACTORY STYLE CJ REPLACEMENT HARNESS |
 |
#10110
- For 1975-86 CJ Series Jeeps. Almost every circuit on this harness
is pre-terminated at both ends on this three section harness. All wires
are color coded and labeled and all wire leads are pre-cut to proper
lengths. Our harness uses an OEM style bulkhead connector that attaches
to the bulkhead without any special brackets or modifications. The blade-type
fuse block wiring is factory terminated and machine crimped. The most
Painless way to wire your 75-86 CJ Series Jeep. |
NOTE:
This harness is fully grounded for use with fiberglass Jeep bodies.
|
|
| ENGINE
SECTION Chassis ground, brake failure warning switch, horn, windshield washer, heater motor, park and signal lights, front marker light (w/bulb socket), headlights, sending units, starting, charging, ignition circuits, tachometer lead, ballast resistor, maxi fuse, terminal ends, wire ties and grommets. |
|
MAIN BODY SECTION Heavy duty blade style ATO fuse block, heater switch, blower motor resistor, dimmer switch, ignition switch, turn signals, headlight switch, windshield wiper power, turn signal indicators (with bulb socket), high beam indicator (with bulb socket), dome lamp ground and power, neutral safety switch, stop light switch, dash indicator lamps, backup lamp switch, water temp gauge (with illumination sockets), oil pressure gauge (with illumination sockets), fuses, flashers, horn relay and emergency brake switch. ear harness, rear marker lights (with bulb sockets), rear lamp ground and tail light housing (4 wire). |
| REAR SECTION Main harness-to-rear harness, rear marker lights (with bulb sockets), rear lamp ground and tail light housing (4 wire). |
| NOTE: Harness #10110 is NOT equipped for computer controls nor is it engine specific. Water temp sender, oil gauge sender, alternator, starter solenoid, tach lead, ballast resistor and fuel tank sender are NOT pre-terminated. |
| Part No. | Description / Application | RJay's Price | Buy It! |
| PWI10110 | 1975-86 CJ Series Jeep Chassis Harness | $515.00 |
| 12 CIRCUIT JEEP CJ HARNESSES |
 |
#10105 - CJ-2/CJ-5 Thru 1974 where the wires run through a grommet in the bulkhead and the key is in the dash. #10106 - CJ-6/CJ-7 1975 & On. Uses the factory-style bulkhead connector so no special brackets are required. |
| These factory upgrades
use the OEM style fuse block and TXL high temp wire for trouble free performance. Open ended wire leads allow for custom routing of wires. Both kits include standard 12-circuit features. #10106 includes additional GM pre-wired plugs for ignition switch, dimmer switch and turn signals. |
| Part No. | Description / Application | RJay's Price | Buy It! |
| PWI10105 | CJ-2/CJ-5 Thru 1974 Chassis Harness | $355.00 | |
| PWI10106 | CJ-6/CJ-7 1975 & On Chassis Harness | $369.00 |
 |
| 12 CIRCUIT WEATHERPROOF HARNESSES |
 |
The
best wiring harnesses for rough off-road conditions just got better
with the introduction of these three new weatherproof harnesses. On
top of the already superior Painless design and materials, these tough
new kits feature: - Weatherproof fuse block with clear O-ring-sealed cover - Weatherproof heat-sealed crimp-on terminals - Weatherproof horn relay - Machine crimped splices with weatherproof shrink tubing |
| Part No. | Description / Application | RJay's Price | Buy It! |
| PWI10140 | Universal - 12 Circuit Weatherproof Chassis Harness | $469.00 | |
| PWI10142 | Jeep CJ2/CJ5 - 12 Circuit Weatherproof Chassis Harness | $459.00 | |
| PWI10143 | Landcruiser/Scout - 12 Circuit Weatherproof Chassis Harness | $459.00 |
 |
||||||||||
7079
Hwy ZZ / Cuba, MO 65453
All Materials Copyright © 1999-2008 RJay's Performance Center, LLC Reproduction of any material prohibited without written permission. Contact website owner: RJay's Webmaster |
| |
| top |