Where You Can Find It!

Find it at RJay's!

LOKAR PERFORMANCE PRODUCTS

BILLET SPECIALTIES

Flaming River

PETE & JAKE'S HOT ROD PARTS

SUPER BELL AXLES

DIRECT SHEETMETAL


RJAYS DOT COM - THE PLACE TO SHOP!
 

Sizes shown are largest expected size. Sizes may vary slightly in each individual series. For questions or further information on installation procedures, you can contact Autometer's Service department at (815) 895-8141 or service@autometer.com...............Thanks, RJay

Specification B1:
2-1/16" ELECTRICAL & MECHANICALS

Hole Size: 2-1/16"
Includes all necessary hardware & 12V lighting. Dashed Bezel & Lens apply to the Street Rod Series. The Street Rod Bezel is 1/64" smaller than Super Bezel.




Specification D1:
3-1/8" In-Dash
Hole Size: 3-1/8"
Includes all necessary hardware & 12V lighting.
See our Tech Tips section for Speedometer Calibration.




Where can I purchase speedometer cables and how can I calibrate my speedometer?

Speedometer cables may be purchased at RJay's or your local auto parts store. Auto Meter speedometers come with a standard 5/8" x 18 threaded cable input that requires a .104" sq. male drive. The speedometer is calibrated for a 1:1 drive ratio (1,000 RPM at 60 MPH input at the speedometer head.)

If the vehicle tire size and/or rear end differential are not stock, a different driven gear in the transmission may be required for speedometer accuracy. If a change in the driven gear is made, you very likely will also have to change the drive gear in the transmission to maintain the proper gear tooth arrangement. Another approach is to use a "correcting ratio" drive joint to adjust the speedometer input to 1,000 RPM at 60MPH. The ratio can be determined by comparing your speedometer reading against another car having an accurate speedometer and dividing the same speed (Accurate speed / Your speed = Ratio needed.) Auto parts stores or speedometer specialty shops (see above) carry "correcting ratio" drive joints.

Also, see electronic speedometers throughout our online catalog. These speedometers are programmable and feature push button calibration. They can be calibrated repeatedly with tire and gear changes. Senders are available to convert from mechanical take off or electronic sensor.




















RJay's Speed Shop, LLC
434 East 3rd St. / Adrian, MO 64720
Contact RJay's Speed Shop
Phones: e-mail:
Toll Free: 1-800-258-4204 Tech/Parts Questions
Phone: 1-816-291-4575 Order Inquiries
Fax: 1-816-841-4721 General Mailbox
All Materials Copyright © Flying A Motorsports, Inc.
Reproduction of any material prohibited without written permission.

top